We cut out sections of sheet rock,following the wire.There are all manner of obstacles,you are cutting blind.
Here's the point where it goes up and across the ceiling,we couldn't follow that path and had to go across the doorway.
The door way that the HVAC guys had just installed that big ass duct,further complicating our task.4 #10 wires clad in metal is not very forgiving,and we had to go through three metal studs at each corner,sharp angles with uncooperative material.And you can't bully it through because the metal clad can separate and then you have to pull it out and start all over again.Fortunately this did not happen because Chuck and I are such bad ass electricians.
Finally...we made it to the panel.My camera phone sucks.But I think you get the picture.
No comments:
Post a Comment